WHAT ARE THE COMMON DIODE TYPES?
Depending on their applications, diodes can be segregated into the following major divisions:
Small Signal Diode.
These are the semiconductor devices used most often in a wide variety of applications. In general purpose applications, they are used as a switch in rectifiers, limiters, capacitors, and in wave shaping.
The common diode parameters a designer needs to know include forward voltage, reverse breakdown voltage, reverse leakage current, and recovery time.
Silicon Rectifier Diode.
These are the diodes that have high forward-current carrying capability, typically up to several hundred amperes. They usually have a forward resistance of only a fraction of an ohm while their reverse resistance is in the megaohm range.
Their primary application is in power conversion, such as for power supplies, UPS, rectifiers=inverinverters etc. In case of current exceeding the rated value, their case temperature will rise. For stud mounted diodes, their thermal resistance is between 0.1 to 1# C=W.
Zener Diode.
Its primary applications are in the voltage reference or regulation. However, its ability to maintain a certain voltage depends on its temperature coefficient and impedance.
The voltage reference or regulation application of Zener diodes are based on their avalanche properties. In the reverse-biased mode, at a certain voltage the resistance of these devices may suddenly drop. This occurs at the Zener voltage VX , a parameter the designer knows beforehand.
Figure 2.4 shows a circuit in which a Zener diode is used to control the reference voltage of a linear power supply.
Under normal operating conditions, the transistor will transmit power to the load (output) circuit. The output power level will depend on the transistor base current.
A very high base current will impose a large voltage across the Zener and it may attain Zener voltage VX , at which point it will crush and limit the power supply to the load.
Photodiode.
When a semiconductor junction is exposed to light, photons generate hole-electron pairs. When these charges diffuse across the junction, they produce photo current. Hence this device acts as a source of current that increases with the intensity of light.
Light-Emitting Diode (LED).
Power diodes used in PE circuits are high-power versions of the commonly used devices employed in analog and digital circuits. They are manufactured in many varieties and ranges. The current rating can be from a few amperes to several hundreds while the voltage rating varies from tens of volts to several thousand volts.
No comments:
Post a Comment